How it packs

Four steps

  1. 01

    Every way up

    Type the three sides in any order. Each item is tried in all six square-on orientations, so a 30 × 10 × 5 cm item with 5 mm of foam fits any case at least 31 × 11 × 6 cm inside, whichever way round you entered it.

  2. 02

    Biggest first, small in the gaps

    The largest piece goes in first. Each next piece tries every open corner and every rotation, on the floor, on top of or between earlier pieces, and takes the spot that grows the load least. The packer keeps the best three part-built loads alive at each step, and reruns the whole thing in up to four orders (biggest, longest, widest footprint, grouped items first).

  3. 03

    Repacked for every case

    Each case gets its own pack against its own walls. The same gear lies side by side in a shallow case and stacks in a deep one. Where we know how deep the base is, the packer keeps your gear below the lid line when it can, and the result card tells you if it reaches into the lid.

  4. 04

    Closest fit first

    The fit score measures how much of the interior your gear plus its foam fills, on all three axes. Results start at the snuggest. Cases far roomier than your best match are left out, so the list is the sensible fits rather than every box the gear would rattle around in. Change the sort for lowest price, top sellers or lightest, and select a result's photo to see the pack in 3D.

Settings that change the pack

Foam, gap and stacking sit under the item list. Orientation and grouping appear when you turn on Orientation and grouping.

  • Foam around your gear

    Foam between your gear and every wall, floor and lid included. It counts on both sides, so 5 mm of foam needs 1 cm extra on each axis.

  • Gap between items

    Each piece packs inside a margin this thick. Neighbours touch the margin, never the gear, so the gap survives. Only used with two or more pieces.

  • Allow stacking

    On by default. Turn it off and every piece sits in one layer on the floor, so only cases wide enough for the whole spread match.

  • Quantity

    Set Qty to 3 to pack three copies without retyping them. They pack as separate pieces and share one colour in the 3D view.

  • Any, Upright or Flat

    Upright keeps the Height side vertical; the item can still turn on the spot. Flat lays it on its side: Height runs along the floor and the shorter of Length and Width points up.

  • Group

    Shows when Qty is above 1. Copies pack side by side as one block whenever they fit that way. It never rules out a case: if they can't stay together, they split into as few bunches as possible.

Loading rules

A fit only counts if a person could load it that way: square to the walls, resting on something solid, right way up.

  • Fill the gaps Allowed

    A later piece can drop into the space between two placed pieces, as well as beside or on top of them.

  • Bridge level tops Allowed

    A piece can rest across two below it when their tops are level, they touch, and they cover its whole underside.

  • Tilting Not allowed

    Pieces sit square, at 90° turns only. No rods across the diagonal or panels leaning on a wall.

  • Hollows underneath Not allowed

    Everything rests fully on the floor or on the pieces below. No plank across an empty gap.

  • Overhangs Not allowed

    Nothing balances past the edge of what is under it, so stacks can't topple in transit.

  • Tipped stacks Not allowed

    A stack is built by gravity and stays that way up. It never flips onto its side to squeeze in.

Measure once, check every case. Type in your gear and the packer tries it in each case we stock.

Open the case finder